Airsoft HPA

Kuulutusi: 7 Hinnang: 1 2 3 4 5 0.0

Esita päring

Sinu nimi:

Sinu e-post:

   

Sinu küsimus:

Märkus: HTML kood ei ole lubatud!

Sisestage pildil nähtav kontrollkood:

The most important development of the new generation 2 Proline is undoubtedly the original addition of an ETU electronic trigger and a protection mosfet. This trigger allows increased responsiveness, finer trigger travel sensitivity, low voltage battery protection, gearbox collar cycles, spring pre-compression for a much faster start of shooting, etc. small revolution, always at an affordable price.

Tan hand guard and upper and black lower version

Gearbox Gen 2 Proline:

• Lancer Tactcial Engraved Metal Gearbox Shells
• Steel gears ratio 18:1
• Delay
• Bearings 8mm
• 14 tooth steel piston
• Red anodized cylinder for improved surface finish
• Hi-speed Neodyn magnet motor 25000 rpm
• Steel QD spring guide on bearings
• Quick spring change (QD)
• Shielded low resistance cabling
• Hi-speed metal trigger
• “Fast trigger” electronic trigger block with increased responsiveness and higher rate of fire
• 16AWG shielded wiring (rear)
• Protective mosfet in the butt tube (battery protection)

Internal parts:

• 6.03mm precision barrel in polished brass
• Hop-up block with central wheel (Gen 2)
• Hop-up joint 50°

External parts:

• Metal body
• External metal barrel
• Folding nylon fiber sight
• Ergonomic metal trigger guard
• M-LOK handguard
• Single-point steel strap attachment
• Delta stock
• Metal stock tube
• Steel false cylinder head
• Steel cocking lever with hi-speed handle
• Steel magazine catch
• Bolt catch (fictional) made of metal
• Mid-cap polymer magazine 140 rounds
• Semi and full auto